HP-UX Containers (SRP) A.03.01.007 Release Notes (766153-002, May 2014)

If the system has an operating system older than HP-UX 11i v3, March 2012 release, you must first
update your system to HP-UX 11i v3 March 2012 or later release before installing HP-UX Containers
A.03.01.007.
The srp_migrate utility migrates existing HP-UX-SRP A.02.02
workload SRPs to HP-UX Containers
A.03.01 and later workload containers. The HP-UX SRP A.02.02 workload SRPs are not visible in the
HP-UX Containers A.03.01.007 environment until you run the srp_migrate utility.
1.6.1 Upgrade requirements
• HP-UX Containers A.03.01.007 can only migrate systems running HP-UX SRP A.02.02 and
later.
• When upgrading from an HP-UX Containers A.03.00 enabled environment to HP-UX
Containers A.03.01.007, all existing containers will be updated during software installation
to support HP-UX Containers A.03.01.007. All containers must conform to the configuration
requirements described in 1.5.2 Configuration requirements before you can successfully start
the containers.
• HP-UX SRP A.02.02 SRPs can only be migrated to HP-UX Containers A.03.01 and later
workload containers.
1.6.2 Upgrade instructions for HP-UX SRP A.02.02
After installing HP-UX Containers A.03.01.007, the product will be disabled. You can migrate
existing HP-UX SRP A.02.02 containers as follows:
1. You must first enable HP-UX Containers using the srp_sys command. You can either use the
–enable or the –setup option to enable HP-UX Containers. The srp_sys –enable
command will automatically migrate all existing A.02.02 workload SRPs to A.03.01.007
workload containers. The srp_sys –setup command will provide you the option to select
which A.02.02 workload SRPs to migrate to A.03.01.007 workload containers.
For more information about the srp_sys command, see HP-UX Containers (SRP) A.03.01
Administrator’s Guide.
2. For any workload SRPs that have not been migrated, you can run the srp_migrate utility
to migrate any remaining workload SRPs:
# /opt/hpsrp/bin/util/srp_migrate
3. Verify that all containers have been successfully migrated and are recognized by the system:
# srp –status
The migrated workload containers will be in the stopped state by default.
4. HP-UX Containers A.03.01 and later delivers new default configuration in the following
configuration files:
/etc/opt/hpsrp/cmpt/base.srp_incl
/etc/opt/hpsrp/templates/srpdefaults.cst
If you modified these two configuration files in an earlier release, you must manually
incorporate your prior changes into the A.03.01.007 version of these two files. If you
modified these files before the upgrade, they will be renamed to base.srp_incl.old and
srpdefaults.cst.old.
8