HP-UX Containers (SRP) A.03.01.003 Release Notes (5900-2312, May 2012)
6
1.5.5 Removing (un-installing) HP-UX Containers product
Use the following steps to remove (un-install) HP-UX Containers product from your HP-UX 11i v3
March 2012 (or later) system:
1. Logon to the system as the root user.
2. Stop all configured containers:
# srp -stop container_name
3. Remove all configured containers:
# srp -delete container_name
4. Disable HP-UX Containers :
# srp_sys -disable
5. Remove the HP-UX-SRP bundle:
# swremove –x autoreboot=true HP-UX-SRP
NOTE: Only the HP-UX-SRP bundle will be removed from the system. All other product
bundles included in the HP-UX Containers A.03.01.003 bundle will remain on the system.
6. Use the swlist command to verify that the HP-UX-SRP bundle is removed from the system.
The swlist command will not report the components of HP-UX-SRP if they were successfully
removed from the system.
# swlist HP-UX-SRP
1.6 Upgrading to HP-UX Containers A.03.01.003
HP-UX Containers A.03.01.003 supports upgrades from HP-UX SRP A.02.02 and later. If you have
workload SRPs configured using HP-UX SRP A.02.02 and you need to continue using them, you can
migrate the workload SRPs to workload containers after the upgrade. Before you install HP-UX
Containers A.03.01.003, make sure that all configured containers are stopped.
If the system has an operating system older than HP-UX 11i, March 2012 release, you must first
update the system to March 2012 release before installing HP-UX Containers A.03.01.003.
The srp_migrate utility migrates existing HP-UX-SRP A.02.02 workload SRPs to HP-UX Containers
A.03.01 and later workload containers. The HP-UX SRP A.02.02 workload SRPs are not visible in the
HP-UX Containers A.03.01.003 environment until you run the srp_migrate utility.
1.6.1 Upgrade requirements
HP-UX Containers A.03.01.003 can only migrate systems running HP-UX SRP A.02.02 and
later.
When upgrading from an HP-UX Containers A.03.00 enabled environment to HP-UX
Containers A.03.01.003, all existing containers will be updated during software installation
to support HP-UX Containers A.03.01.003. All containers must conform to the configuration
requirements described in 1.5.2 Configuration requirements before you can successfully start
the containers.