HP-UX Containers (SRP) A.03.01 Administrator's Guide

34
#
# sshd configuration
#
##############################
Checking sshd configuration ... [ Not Enabled ]
The Secure Shell daemon (sshd) in the global view is listening to all IP
addresses.
This will interfere with Secure Shell daemons in SRP containers.
Restrict the IP addresses that sshd listens to in the global view? [y] RETURN
Enter IP addresses, separated by comma ',': [16.92.124.238]
sshd will then listen on these interfaces: 16.92.124.238
Saving changes to /opt/ssh/etc/sshd_config [ OK ]
Restarting Secure Shell daemon ... [ OK ]
##############################
#
# IPFilter Setup
#
##############################
Checking IPFilter module ... [ Not Enabled ]
HP recommends that you do not enable or disable HP-UX IPFilter when critical
network applications are running. HP recommends that you schedule enabling or
disabling IPFilter when interrupting network connectivity is not disruptive.
Enable IPFilter for SRP? [n] RETURN
##############################
#
# IPsec configuration
#
##############################
Checking IPsec module ... [ Not Installed ]
##############################
#
# SRP setup completed.
#
##############################
Warning: compartment feature change will not take effect until the
system is rebooted.
Warning: requested kernel tunable changes will not take effect until the
system is rebooted.
Reboot system now (cd /; shutdown -r now)? [y] RETURN
5.2 Displaying subsystem properties
You can use the srp_sys –list command to review the current settings for system-wide
configuration options affecting HP-UX Containers. For each of the subsystems configured with the
srp_sys –enable or srp-sys –setup command, the srp_sys –list command displays the
current configuration status. The possible configuration status values are:
Status Description
OK
The subsystem is installed, enabled and configuration has been validated.
Enable on Boot
The subsystem requires a reboot, and will be enabled once a reboot has
been performed.
Invalid Config
The subsystem is installed and enabled but has failed the configuration