HP-UX Containers (SRP) A.03.00 Release Notes

6
NOTE: Only the HP-UX-SRP bundle and the FsSrp product will be removed from the system.
All other product bundles included in the HP-UX Containers A.03.00 bundle will remain on
the system.
6. Use the swlist command to verify that the HP-UX-SRP bundle is removed from the system.
The swlist command will not report the components of HP-UX-SRP if they were successfully
removed from the system.
# swlist HP-UX-SRP
1.6 Upgrading to HP-UX Containers A.03.00
HP-UX Containers A.03.00 supports upgrade from HP-UX SRP A.02.02 version. If you have workload
SRPs configured using HP-UX SRP A.02.02 and you need to continue using them, you can migrate the
workload SRPs to workload containers after the upgrade. Before you install HP-UX Containers
A.03.00, make sure that all configured containers are stopped.
If your system has an operating system older than HP-UX 11i, March 2011 release, you must first
update your system to March 2011 release before installing HP-UX Containers A.03.00.
The srp_migrate utility migrates existing workload SRPs to HP-UX Containers A.03.00 workload
containers. The HP-UX SRP A.02.02 workload SRPs are not visible in the HP-UX Containers A.03.00
environment until you run the srp_migrate utility.
1.6.1 Upgrading requirements
• Only systems running HP-UX SRP A.02.02 can migrate to HP-UX Containers A.03.00
• HP-UX SRP A.02.02 SRPs can only be migrated to HP-UX Containers A.03.00 workload
containers. To deploy HP-UX SRP A.02.02 SRPs as HP-UX Containers A.03.00 system
containers, you must delete the A.02.02 workload SRPs and manually migrate the content
into newly created system containers on your HP-UX Containers A.03.00 system.
1.6.2 Upgrading instructions
You can migrate existing HP-UX SRP A.02.02 containers as follows:
1. You must first enable HP-UX Containers using the srp_sys command. You can either use the
–enable or the –setup option to enable HP-UX Containers.
The srp_sys –enable command will automatically migrate all existing A.02.02 workload
SRPs to A.03.00 workload containers.
The srp_sys –setup command will provide you the option to select which A.02.02
workload SRPs to migrate to A.03.00 workload containers.
Refer to the HP-UX Containers (SRP) A.03.00 Administrator’s Guide for more information
about the srp_sys command.
2. For any workload SRPs that have not been migrated, you can run the srp_migrate utility
to migrate any remaining workload SRPs:
# /opt/hpsrp/bin/util/srp_migrate