HP-UX Containers (SRP) A.03.00 Administrator's Guide

5 Configuring HP-UX Containers using the srp_sys

command

The /opt/hpsrp/bin/srp_sys command is used to enable, disable, view, and update system-

wide configuration properties that affect the HP-UX Containers product.

The srp_sys command has the following syntax:

srp_sys [-s[etup]]

srp_sys [-e[nable]]|[-d[isable]] [subsystems[,...]] [variable=value [...]]

srp_sys [-l[ist]] [subsystems[,...]] [-v[erbose]]

srp_sys [-h[elp]]

Where:

setup

Interactive option - Performs system level configuration and verification for

HP-UX Containers.

enable

Non-interactive option - Performs the necessary configuration and

enablement actions for the specified subsystem. If no subsystem is specified,

the default subsystems required for HP-UX Containers will be enabled.

disable

Disables various system wide HP-UX Container configuration properties. If

no subsystem is specified, all the subsystems will be disabled.

list

Lists the configuration status of system wide configuration properties used

by HP-UX Containers.

help

Displays usage information for the srp_sys command.

verbose

Displays detailed information for the –list operation.

subsystem

A specific group of configurations to be enabled. Valid values: coreset,

migrate, cmptlogin, prm, ipfilter, ipsec, and sshd.

variable

Valid variables:

sshdlistenip

and

prmsubsys

See srp_sys(1M) for more information.

5.1 Configuring the system for HP-UX Containers

After the HP-UX Containers product installation completes, you must prepare the system for HP-UX

Containers using the srp_sys command. The HP-UX Containers features require a set of subsystems

to be configured on the system. You can enable the subsystems required for HP-UX Containers in one

of two ways:

• Using srp_sys with the –enable option: