HP-UX Containers (SRP) A.03.00 Administrator's Guide

19
4.3 Accessing SRP Manager help
To access help information for any SRP Manager page, click the question mark icon located
in the upper right corner of the SRP Manager homepage.
4.4 Setting the HP-UX Containers environment
Before you can create any container, you must setup your HP-UX Containers environment. The system
properties verify that the subsystem level configuration meets the requirements to configure a container
on the host. To use the HP-UX Containers technology, you must enable the core subsystem properties
before creating containers on the system by either using
the srp_sys command (with the –enable
or –setup option) or by using the SRP Manager.
To enable HP-UX Containers technology using the SRP Manager, follow these steps:
1. Go to the System Properties tab.
2. Click the Enable button for the SRP core subsystems property.
3. Wait for the successful completion message to appear in the result window.
4. Enable the compartment login feature, the PRM service, and the sshd
configuration properties. Optionally, you can enable other properties.
5. Reboot the system to enable the required properties.
NOTE: The Container Listing tab will only be displayed if the SRP core subsystem property
status is set to OK.
Figure 4.3 shows the System Properties tab after the user enabled the selected system properties
and rebooted the system.
Figure 4.3 Enabling the system properties
NOTE: From the SRP Manager help files, select the Properties help menu item for more information
on the System Properties page.