HP CIFS Server 3.0b Administrator's Guide version A.02.01.01

Winbind Support
Configuring HP CIFS Server with Winbind
Chapter 7 167
When you run the ll -n command, the UID, 1002, and GID, 1505,
are displayed in the output. Both UID and GID are in the range of values
that we specify in the smb.conf file for winbind to use.
Starting and Stopping Winbind
This section describes how to start or stop the HP CIFS Server with
winbind support.
Starting Winbind
Use the startsmb -winbind or startsmb -w command to start winbind
daemon on the P CIFS Server as follows:
startsmb -winbind
or
startsmb -w
Stopping Winbind
Use the stopsmb -winbind or stopsmb -w command to stop winbind
daemon on the P CIFS Server as follows:
stopsmb -winbind
or
stopsmb -w
NOTE Use the scripts, startwinbind and stopwinbind, to start or stop the
winbind daemon only without the smbd and nmbd daemons. For
example, use the following command to start the winbind daemon only:
startwinbind