HP CIFS Client A.01.09 Administrator's Guide, August 2003

Installing, Configuring, and Using the HP CIFS Client
Step 3: Configuring the HP CIFS Client
Chapter 228
serverCharMapFile = "/etc/opt/cifsclient/unitables/unimapShiftJIS.cfg";
clientCharMapFile = "/etc/opt/cifsclient/unitables/unimapShiftJIS.cfg";
3. Authentication Level
The configuration parameter, authenticationLevel, should be set
to ntlm or kerberos. See “HP CIFS Authentication Using Kerberos”
for details.
4. HP recommends that no other configuration modification be made to
this file. Because of limitations of the Windows file system, however,
two configuration settings must be carefully considered for your
operating environment: execMapping and caseSensitive. These are
discussed in Configration File Chapter. Also, see the discussion of
case sensitivity in the HP CIFS Server manual in the section “Other
Samba Issues.”
Because of limitations of the Windows file system, however, two
configuration settings must be carefully considered for your operating
environment: execMapping and caseSensitive. These are discussed in
Chapter 5. Also, see the discussion of case sensitivity in the HP CIFS
Server manual in the section “Other Samba Issues.”
NOTE As of this revision, Samba does not support Unicode. Windows NT and
Windows 2000 use Unicode by default.