HP Caliper User's Guide

• --latency-buckets

• --per-module-data

Deleted Information

None.

Document Organization

For information to help you get started, read these chapters:

• “HP Caliper at a Glance” (p. 23) provides an introduction to HP Caliper.

• “Getting Started with the HP Caliper Command-Line Interface” (p. 29) helps you

get started using the HP Caliper command-line interface.

• “Getting Started with the HP Caliper GUI” (p. 43) introduces you to the HP Caliper

graphical user interface (GUI).

For more advanced information, read these chapters:

• “HP Caliper Measurement Configuration Files” (p. 57) describes the measurement

configuration files provided with HP Caliper.

• “HP Caliper Options” (p. 63) describes the HP Caliper options in alphabetical

order.

For information about the HP Caliper Advisor, read this chapter:

• “Using the HP Caliper Advisor” (p. 101).

For information about how to configure HP Caliper to collect data and report the results,

read these chapters:

• “Configuring HP Caliper ” (p. 121) describes how you can configure HP Caliper

to collect data.

• “Controlling the Content of Reports” (p. 137) describes how to control the content

of reports based on the data collected.

For information about how to run particular measurements, read these chapters:

• “Producing a Sampled Call Graph Profile Analysis” (p. 157) describes how to use

HP Caliper to produce a sampled call graph profile analysis.

• “Producing a Sampled Call Stack Profile Analysis” (p. 171) describes how to use

HP Caliper to produce a sampled call stack profile analysis.

• “Performing CPU Metrics Analysis ” (p. 197) describes how to measure CPU

metrics on HP-UX.

For information about HP Caliper features specific to HP-UX, read this chapter:

• “HP Caliper Features Specific to HP-UX ” (p. 199).

Also see these appendixes: