HP Auto Port Aggregation Administrator's Guide HP-UX 11i v3 (766140-001, March 2014)

E Switch configuration information

This appendix provides some information on how to configure the following switches for use with

HP APA:

• Cisco

• HP Procurve

See your switch documentation for complete information.

Cisco 3120X switches

This section describes the following tasks:

• Configure a single port

• Show a single link

• Create an LACP link aggregation

• Create a FEC link aggregation

NOTE:

◦ PAgP cannot be enabled on 3120G/X switches configured in a cross-stack EtherChannels

while LACP is supported on cross-stack EtherChannels.

◦ FEC is not supported in CISCO 3120X switches configured on a cross-stack

ETHERChannels, while LACP is supported on a cross-stack ETHERChannels.

◦ The information in this section pertains to Cisco IOS Version 12.2.

For information about Cisco 3120X switches see Cisco software configuration guide

and Cisco hardware installation guide .

This link will take you outside the Hewlett-Packard (HP) Web site. HP does not control

and is not responsible for information outside of HP.com.

Configuring a single port

Router1#config term

config command

Ctrl+z

Switch1#interface gigabitethernet 9/5

Switch1(config-if)#switchport

Switch1(config-if)#no shutdown

Switch1(config-if)#end

Enter configuration commands, one per line. End with Ctrl+z or end.

Showing a single port

cisco2#show interface GigabitEthernet 1/0/3

GigabitEthernet1/0/3 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet, address is 04c5.a4be.8003 (bia 04c5.a4be.8003)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseX

input flow-control is off, output flow-control is unsupported

ARP type: ARPA, ARP Timeout 04:00:00

Cisco 3120X switches 97