HP Auto Port Aggregation Administrator's Guide HP-UX 11i v3 (766140-001, March 2014)

Example 6 nwmgr Verbose Output (Link Aggregate)
# nwmgr -S apa -I 920 -v
lan920 current values:
Speed = 2 Gbps Full Duplex
MTU = 1500
Virtual Maximum Transmission Unit = 0
MAC Address = 0x00127942FC38
Network Management ID = 46
Features = Linkagg Interface
IPV4 Recv CKO
IPV4 Send CKO
VLAN Support
VLAN Tag Offload
64Bit MIB Support
Load Distribution Algorithm = LB_MAC
Mode = LACP_AUTO
Parent PPA = -
APA State = Up
Membership = 13,14
Active Port(s) = 13,14
Not Ready Port(s) = -
Key = 920
Operational Key = 920
Example 7 nwmgr All Attributes Output (Link Aggregate)
# nwmgr -S apa -I 920 -A all
lan920 current values:
Speed = 2 Gbps Full Duplex
MTU = 1500
Virtual Maximum Transmission Unit = 0
MAC Address = 0x00127942FC38
Network Management ID = 46
Features = Linkagg Interface
IPV4 Recv CKO
IPV4 Send CKO
VLAN Support
VLAN Tag Offload
64Bit MIB Support
Load Distribution Algorithm = LB_MAC
Mode = LACP_AUTO
Parent PPA = -
APA State = Up
Membership = 13,14
Active Port(s) = 13,14
Not Ready Port(s) = -
Group Capability = 5
Key = 920
Operational Key = 920
Polling Interval = 0
Dead Count = 0
Rapid ARP = off
Rapid ARP Interval = 0.0 second(s)
Rapid ARP Count = 0
Failover Policy = -
Creating a LACP mode link aggregate
To create a LACP link aggregate lan900 from ports lan1 and lan2, enter the following command:
# nwmgr -s -A key=900,mode=LACP_AUTO -I 1 -S apa
lan1 new values:
Mode = LACP_AUTO
46 Using the nwmgr command