HP Auto Port Aggregation Administrator's Guide HP-UX 11i v3 (766140-001, March 2014)

specifying in hp_apaconf file, 78
LB_PORT algorithm, 26
link aggregate
and TSO, 10
and VLAN, 92
configuring, 27
configuring by editing files, 85–86
configuring FEC_AUTO mode by editing files, 85–86
configuring IP address, 30
configuring LACP_AUTO mode by editing files, 85–86
configuring MANUAL mode by editing files, 85–86
creating, 27
creating with nwmgr command, 46
deleting, 32
description, 8
displaying details, 34
in failover groups, 22
including in failover group, 9
maximum number of, 35
modifying, 32
not enabled, 25
parameters for, 77
sample syslog status messages, 36
verifying active ports (FEC_AUTO mode), 59
verifying active ports (LACP_AUTO mode), 55
verifying configuration (FEC_AUTO mode), 58
verifying configuration (LACP_AUTO mode), 52
verifying if enabled (FEC_AUTO mode), 58
verifying if enabled (LACP_AUTO mode), 53
verifying member ports (FEC_AUTO mode), 59
verifying member ports (LACP_AUTO mode), 53
link partner
configuring, 30
verifying configuration (failover group), 62
verifying configuration (FEC_AUTO mode), 58
verifying configuration (LACP_AUTO mode), 52
linkloop command
and corresponding nwmgr command, 47
deprecation note, 41
LM_RAPID_ARP, 83
LM_RAPID_ARP_COUNT, 83
LM_RAPID_ARP_INTERVAL, 83
load balancing, 26
see also load distribution
algorithm, 9
description, 8
parameter, 78
load distribution, 26
log
syslog, 36
M
MAC address
and failover group, 9, 27
and link aggregate, 8
load balancing, 26
specifying in hp_apaconf file, 77
MANUAL mode
configuring by editing files, 85–86
Maximum Transmission Unit see MTU
message, 36
see also status message
MTU
virtual, 10
N
netconf file, 87
and IP address, 8
nettl command, 69
TSO status messages, 71
network adapter see NIC
Network Interface Card see NIC
network is unreachable message
in failover group, 65
in FEC_AUTO mode link aggregates, 60
in LACP_AUTO mode link aggregate, 55
NIC
supported, 14
verifying claiming, 51
verifying installation, 51
verifying operation, 51
nwmgr command, 12
creating a MANUAL mode link aggregate, 46
deleting an HP APA interface, 47
displaying all attributes for link aggregates, 46
displaying all interfaces, 42
displaying link aggregate verbose information, 45
displaying statistics, 38
displaying verbose failover group information, 43
HP APA tasks, 41
overview, 41
performing a CRA operation, 47
resetting a data flow, 47
verifying HP APA configuration, 31
verifying TSO support, 10
O
Operation Successful page, 28
delete link aggregate, 34
outbound data transfer, 26
P
packet loss, 58
packet ordering, 9
parameter, 35
see also global parameter
permission denied message
in failover group, 67
in FEC_AUTO mode link aggregates, 61
in LACP_AUTO mode link aggregate, 56
ping command, 68
polling interval
specifying in lanconfig.ascii file, 83
specifying on configuration worksheet, 27
POLLING_INTERVAL, 83
port
verifying active in failover group, 64
verifying membership in failover group, 63
107