HP Auto Port Aggregation Administrator's Guide HP-UX 11i v3 (766140-001, March 2014)

Displaying more LACP information
cisco2#show lacp 1 neighbor
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 1 neighbors
Partner's information:
LACP port Admin Oper Port Port
Port Flags Priority Dev ID Age key Key Number State
Gi1/0/5 SA 0 d4c9.ef06.945e 26s 0x0 0x384 0x4 0x3D
Gi1/0/13 SA 0 d4c9.ef06.945e 26s 0x0 0x384 0x2 0x3D
Deleting a link aggregation
Switch1(config)#no interface port-channel 1
Switch1(config)#no interface port-channel 5
Switch1(config)#end
Procurve switches
This section describes information for the Procurve switches:
•
Procurve Switch 3500yl-24G
This section provides the following information that you might find useful in using these switches:
• Flow control is OFF by default in Procurve switches. You must turn the flow control ON for all
the ports. If not saved, power cycling or reboot of the switch will turn the flow control OFF.
• The Procurve 3500yl-24G supports Jumbo frames.
Using graphical user interface for switch configuration:
1. Log in to the switch.
2. Press any key to continue and type Menu
3. Enter 2 (Switch Configuration).
4. Enter 2 (Port/Trunk Settings).
5. Use the arrow key to select edit.
6. Use the arrow key to select a field; press the space bar to cycle choices.
7. When finished, press Enter to return to the action keys.
8. Enter save to save the changes and display the Switch Configuration menu.
9. Enter 0 (zero) to display the Main Menu.
10. Enter 0 (zero) to logout. Then, enter Y to confirm.
Displaying the link aggregation
HP-E6600ml-24XG(config)# show trunks
Load Balancing Method: L3-based (Default), L2-based if non-IP traffic
Port | Name Type | Group Type
---+---------------------------------+--------
13 SFP+SR | Trk1 LACP
14 SFP+SR | Trk2 LACP
15 SFP+SR | Trk2 LACP
16 SFP+SR | Trk1 LACP
HP-E6600ml-24XG(config)# show trunks 14-15
Load Balancing Method: L3-based (Default), L2-based if non-IP traffic
100 Switch configuration information