HP Auto Port Aggregation Administrator's Guide for HP-UX 11i v1 and 11i v2 September 2008

Figure 3-14 Modify Network Physical Port Attributes
12. In this window, make the necessary changes and click OK.
13. Repeat steps 8 through 12 to configure the remaining ports to be in the aggregate. Figure 3-15
shows a sample FEC_AUTO configuration using ports 0 and 1 with a group capability of 7.
Figure 3-15 Example of Configured Link Aggregates
14. From the List pull-down menu, choose the Link Aggregates Supported by HP APA option.
A window similar to Figure 3-16 will appear. Note that the link aggregate might not have
a status of UP immediately because HP APA and the switch or link partner might not have
completed the negotiation required for forming the link aggregation.
Wait for the link aggregate to change status to LINK_UP. Then, configure the IP address on
the link aggregate and continue with the next step.
Configuring a Link Aggregate 39