HP Auto Port Aggregation Administrator's Guide for HP-UX 11i v1 and 11i v2 September 2008

4. The following prompt displays:

HP9304(config)#

TIP: Enter [command name] ? to display the syntax for a command.

Configuring HP APA

To configure HP APA to use the Procurve 9304/8 switch, do the following:

1. Verify port connections before configuring APA. Do the following:

a. Log in to the switch using the previous steps.

b. Enter the interface e [slot]/[port] command. For example:

HP9304(config)#interface e 2/1

c. Enter the following:

HP9304(config-if-e100-2/1)#disable

d. On the server system, verify the LAN is down with the following command:

llp lanx

The command displays output similar to the following:

===========================================================

CMD: linkloop -i 17 0x00306E04945F for hpatm247:lan17 ...

-----------------------------------------------------------

error: expected primitive 0x30, got DL_ERROR_ACK

dl_error_primitive = 0x2d

dl_errno = 0x04

dl_unix_errno = 57

error - did not receive data part of message

Link connectivity to LAN station: 0x00306E04945F

e. On the switch, enter enable.

f. Wait briefly, then on the server system, confirm the LAN has connectivity with the

following command: