HP Auto Port Aggregation Administrator's Guide for HP-UX 11i v1 and 11i v2 September 2008

On the server side, complete the following steps:
1. Create link aggregate lan901.
2. Create failover group lan902.For HP-UX 11i v2 and earlier versions, the primary port in
the failover group must have an IP address configured on it.
3. Create VLANs 333 and 334 over lan902. Enter:
# lanadmin -V create vlanid 333 902
Successfully configured.
lan5000: vlanid 333 name UNNAMED pri 0 tos 0 tos_override
IP_HEADER pri_override CONF_PRI ppa 902
# lanadmin -V create vlanid 334 902
Successfully configured.
lan5000: vlanid 334 name UNNAMED pri 0 tos 0 tos_override
IP_HEADER pri_override CONF_PRI ppa 902
Configuring VLANs over Failover Groups 117