HP-UX AAA Server A.08.02.10 Administrator's Guide HP-UX 11i v3 (T1428-90093, November 2013)

Configuration-Token The Configuration-Token Attribute is supported by the AAA Server
as a reply item and is an implementation specific attribute that
is based upon a lookup table configured outside of the AAA
server. It is used in large distributed authentication networks and
is sent from a RADIUS Proxy Server to a RADIUS Proxy Client in
an Access-Accept message that indicates a type of user profile
to be used.
Port-Limit This attribute sets the maximum number of ports to be provided
to the user by the NAS. It is intended for use in conjunction with
Multilink PPP or similar uses.
Prompt This attribute is used only in Access-Challenge packets and
indicates to the NAS whether it should echo the user's response
as it is entered.
Reply-If-Ack-Message This is a Merit-specific attribute, similar to Reply-Message, that
is only sent in an Access-Accept message.
Reply-Message This attribute indicates text that may be displayed to the user
when the server responds to a request with any RADIUS message.
Different attribute values may be used to add more than one
Reply-Message reply item to an entry.
IMPORTANT: When using the Server Manager interface, you
can define only one Reply-Message value.
NOTE: When using complex policy, it is possible to use the
Reply-Message attribute to send one message when the
authentication succeeds and a different message if the
authentication fails.
Attributes in Accounting Records
This section describes the attributes that may appear in an accounting record. An accounting
record is stored in the HP-UX AAA Server session logs. These attributes may appear in a record
in addition to the basic session information.
Additional Session Information
The following attributes, supported by the HP-UX AAA Server software, may appear in a session
record.
Acct-Status-Type An integer that indicates whether this Accounting-Request marks
the beginning of the user service (Start), the end (Stop), or some
other state. This attribute appears in all accounting messages as
follows:
• 1 (Start)
• 2 (Stop)
• 3 (Interim-Update)
• 7 (Accounting-On)
• 8 (Accounting-Off)
• 9 (Tunnel-Start)
• 10 (Tunnel-Stop)
• 11 (Tunnel-Reject)
414 Attribute-Value Pairs