HP-UX AAA Server A.08.02 Administrator's Guide

information to the HP-UX AAA Server. The HP-UX AAA Server processes the received requests and
returns an ACCEPT or REJECT reply.
Following is the syntax for the radpwtst command:
radpwtst -s server [-a acks] [-c code] [-f fileprefix]
[-g group] [-h][-i clientaddress] [-l asyncport] [-n] [-p port]
[-r retries] [-t timeout] [-u type] [-v version] [-w password]
[-x|X] [[-:attribute=value]...] [-0] userid[@realm]
If radpwtst is successful, the following message is displayed:
authentication OK
If radpwtst fails, the following message is displayed:
'[e-mail]' authentication failed: <reason>
Following is the syntax for the radpwtst command in Dynamic Authorization Server mode:
radpwtst -S [-c code] [-F authorizeonly authport] [-F
require_etimestamp interval] [-F send_mesgauth] [-p port] [-x]
[[-:attribute=value] ...] [-0]
For more information on the radpwtst utility, see radpwtst (1M).
The raddbginc Utility: For Setting Debug Output Levels
The raddbginc utility enables you to set debugging on or off, and to specify the debug level if
the HP-UX AAA Server is running.
For a list of debug levels, see Table 105 (page 375).
Following is the syntax for the raddbginc command:
raddbginc [-h] [-v] [-di ipcdir] pid level
The debug output is sent to the /var/opt/aaa/logs/radius.debug file, unless you specify
a different location using the radiusd command with the -dl option.
For more information on the raddbginc utility, see raddbginc (1M).
The radsignal Utility: For Rolling Over the Debug Output to New Files
The radsignal utility rolls over the logfile (/var/opt/aaa/logs/logfile) and accounting
stream (/var/opt/aaa/acct/session.yyyy-mm-dd.log) output to new files. The radsignal
utility can also be used to set the log level based on the RADIUS message type. For more information
on these files, see “The HP-UX AAA Server Logfile and Debug File” (page 374). The new file can
be identified by the "part number" appended to the file name.
Following is the syntax for the radsignal command:
radsignal [-h] [-v] [[-di ipcdir] pid level] [[ ipcdir] pid roll
logfile] [[-di ipcdir] pid roll stream [stream-name]] [[-di ipcdir]
log level msg_type msg_sub_type log_level ]
For more information on radsignal, see radsignal (1M).
The HP-UX AAA Server Logfile and Debug File
You can use the following logfile and debug file to troubleshoot the HP-UX AAA Server:
• /var/opt/aaa/logs/logfile - The HP-UX AAA Server Logfile
• /var/opt/aaa/logs/radius.debug - The HP-UX AAA Server Debug File
This section discusses the HP-UX AAA Server logfile and debug file.
374 Troubleshooting Resources