HP-UX AAA Server A.07.01 Administrator's Guide

NOTE: The radiusd daemon determines what action must be taken when receiving
requests based upon an FSM that it loads into memory when the server is started. The
FSM can be configured, but it is static after server startup. The server uses the algorithm
shown in Figure 4-3 to determine which FSM must be loaded into memory:
Figure 4-3 Algorithm for Determining Which FSM to Load
IMPORTANT: When started by the inetd service, radiusd times out if it does not
receive a message in 15 minutes. With the -t Timeout option, you can override this
value. If the value is set to 0, it waits indefinitely without timing out.
Configuring the HP-UX AAA Server to Start Automatically Upon System Reboot
You can configure the HP-UX AAA Server (radiusd) and RMI objects to start
automatically after a system reboot.
• Set the RADIUSD variable in/etc/rc.config.d/radiusd.conf to 1. The default
setting is 0.
CAUTION: Modifying the content in the /sbin/init.d/radiusd.rc file other
than radiusd options can disallow booting of the system.
NOTE: You can also start the Server Manager interface after reboot. In the /etc/
rc.config.d/hpws_tomcatconf file, set HPWS_TOMCAT_START to 1, and set
JAVA_HOME to/opt/java1.4.
Stopping or Restarting HP-UX AAA Servers
You must stop or restart AAA servers to update configuration changes.
Stopping or Restarting HP-UX AAA Servers 69