HP-UX Workload Manager A.03.02.xx Release Notes for HP-UX 11i v1, HP-UX 11i v2, and HP-UX 11i v3

HP-UX Workload Manager Release Notes

Compatibility information and installation requirements

d. Restart MeasureWare if it was running before the WLM upgrade/installation:

# /usr/sbin/init.d/mwa start

Step 10. Check the file /var/adm/sw/swagent.log

Check the file /var/adm/sw/swagent.log for messages relating to additional tasks

that may need attention following the swinstall of WLM bundle B8843CA.

Step 11. (Optional) Ensure you have the proper version of GlancePlus

If you plan to use WLM data collectors that are based on Glance Adviser (such as

glance_app or glance_tt), be sure to install and use GlancePlus C.03.35.00 or

later to avoid a memory leak that occurs when Glance Adviser runs continuously. If

you are using HP-UX 11i v1, install GlancePlus when installing the 11i Enterprise

or 11i Mission-critical Operating Environments. If you are using processor sets,

install GlancePlus C.03.58.05 or later.

Step 12. (Optional) Install files for integration with HP Systems Insight Manager

If you plan to use WLM with HP Systems Insight Manager (or Servicecontrol

Manager), install the fileset CMSConfig.WLMB-CMS-Tools on the CMS. This

fileset is available from the depot /var/opt/mx/depot11 on the host where WLM has

been installed.

If you are installing this fileset on a CMS that has WLM installed, the installation

will fail if the fileset is not compatible with (does not have the same revision string

as) the installed WLM.

Step 13. (Optional) Merge new /etc/rc.config.d/wlm file with your modified file

If you have made any modifications to your /etc/rc.config.d/wlm file by setting any of

the variables ending in “_ENABLE” to 1, merge the file

/opt/wlm/newconfig/etc/rc.config.d/wlm with your /etc/rc.config.d/wlm file.

As of WLM A.02.02, the /opt/wlm/newconfig/etc/rc.config.d/wlm file includes the

variables WLMCOMD and WLMCOMD_ENABLE.

NOTE If this was the first time you installed WLM and you have previously installed

PRM, be sure to edit the file /etc/rc.config.d/prm to set the following variables as

indicated:

PRM_CONFIG=0

PRM_RMTCONF=0