HP-UX Workload Manager A.03.00 Release Notes for HP-UX 11i v1 and HP-UX 11i v2

HP-UX Workload Manager Release Notes

Patches and fixes in this version

Step 6. Select OK to install the software after the analysis phase is completed.

Because these products contain kernel filesets, SD will prompt you that a reboot is

necessary.

NOTE If this was the first time you installed WLM and you have not previously

installed PRM, be sure to edit the file /etc/rc.config.d/prm to set the following

variables as indicated:

PRM_CONFIG=0

PRM_RMTCONF=0

These settings prevent PRM and its remote configuration daemon from starting

automatically at reboot. (The PRM remote configuration daemon is not useful

with WLM and does not need to be started.)

Patches and fixes in this version

WLM version A.03.00 includes the following fixes.

Excessive logging of wlmpard messages

Previously, when WLM was configured to manage virtual partitions or nPartitions, all

partitions had to be listed in the wlmpard configuration file. If on a particular partition wlmd

was down or not running, a message similar to the one below was logged every wlmpard

interval:

07/12/04 10:20:02 [W] (p23694) No data received from partition vpar1

The configuration file no longer lists partitions, so wlmpard no longer maintains a list of

partitions from which it expects data.

This fix addresses CR# JAGaf30783.