HP WBEM Services Version A.02.09 Release Notes, First Edition, September 2009

Fixes in this Release
Unless listed in the Known Problems and Workarounds section, all known problems of previous
versions of HP WBEM Services have been fixed in this version.
Table 1-4 describes the defects fixed in HP WBEM Services version A.02.09.
Table 1-4 Defects fixed in HP WBEM Services version A.02.09
ResolutionDescriptionIdentifier
This defect has been fixed to resolve
this error message.
In the Networking page of HP System
Management Homepage, the following
error is displayed:
CIM_ERR_FAILED: Error in ioctl()
request SIOCGIFCONF: Invalid
argument
When this error message is displayed, no
other data can be displayed on the
Networking page.
This error is noticed only with HP WBEM
Services versions prior to A.02.09 on HP-UX
11i v1 and v2 systems on which patch
PHNE_35351 and subsequent patches have
been installed.
QXCR1000890091
The manpage for the osinfo
command has been updated.
The manpage for the osinfo command
does not indicate that the /etc/opt/hp/
sslshare/client.pem file is required
for Client Based Authentication (CBA).
QXCR1000873670
This defect has been fixed to resolve
these error messages.
The cimmof and other WBEM client
commands result in a core dump while
accessing ICU libraries.
With the cimmof coredump, the following
error message is logged in the
swagent.log file:
/var/tmp/BAAa25429/catalog/
WBEMServices/
WBEM-CORE.2/configure[913]:
25842 Memory fault (coredump)
WARNING: Unable to load SD mof
files
With the cimservermain coredump, the
following connection error message is
displayed:
PGS08001: CIM HTTP OR HTTPS
CONNECTOR CANNOT CONNECT
TO 10.162.5.25:5989.
CONNECTION FAILED
QXCR1000914874
Known Problems and Workarounds
The following are the known problems and suggested workarounds for HP WBEM Services
version A.02.09.
16 HP WBEM Services Version A.02.09 Release Notes