HP WBEM Services Version A.02.07 Release Notes, September 2009

Contact your HP support representative for up-to-the-moment information. Patches can be
superseded or withdrawn at any time, so always be sure to check the status of any patch before
downloading it.
Table 1-7 Required Patches
NotesWBEM VersionHP-UX VersionPatches
To support the Domain Name Service,
Network Time Protocol, and Network
Information Service providers, and to avoid
potential problems with multi-threaded
process deadlocks when stressing fork(2)
and directory(3C) (see JAGae84101), this
patch is required.
A.02.07.xx11i v1PHCO_36184
Fixes in this Release
Unless listed in the Known Problems and Workarounds section, all previous WBEM Services
A.02.05 known problems have been fixed in WBEM Services A.02.07.
Table 1-8 Defects Fixed in HP WBEM Services A.02.07.06
ResolutionDescriptionIdentifier
Defects fixed in HP WBEM Services A.02.07.06
This defect has been fixed to resolve this error
message.
In the Networking page of HP System
Management Homepage, the following
error is displayed:
CIM_ERR_FAILED: Error in
ioctl() request SIOCGIFCONF:
Invalid argument
When this error message is displayed, no
other data can be displayed on the
Networking page.
This error is noticed only with HP WBEM
Services versions prior to A.02.07.06 on
HP-UX 11i v1 and v2 systems on which
patch PHNE_35351 and subsequent
patches have been installed.
QXCR1000890091
Defects fixed in HP WBEM Services A.02.07.04
The warning has been changed to a NOTE.
In addition, when the system is restarted after
installing HP WBEM Services, the
cimserver_rc process tries to ensure that the
SSL certificates are generated appropriately. Run
the gen_wbem_certs tool with the -verify
option to verify if the certificates are generated
properly or not. If the certificates are not
generated properly, then run the
gen_wbem_certs tool again.
After cold-installing DC-OE or VSE-OE,
the following warning message is logged
in the /var/adm/sw/swagent.log file:
Warning: Cannot find the
fully-qualified domain name
(FQDN) for this system, SSL
certificates for WBEM Services
are created with the short host
name.
At installation, the SSL certificates for HP
WBEM Services is created with a short
host name. This occurs because the
Fully-Qualified Domain Name (FQDN)
may not be available.
QXCR1000823357
Patches and Fixes in this Version 21