HP WBEM Services Version A.02.07 Release Notes, March 2009

Contact your HP support representative for up-to-the-moment information. Patches can be
superseded or withdrawn at any time, so always be sure to check the status of any patch before
downloading it.
Table 1-7 Required Patches
NotesWBEM VersionHP-UX VersionPatches
To support the Domain Name Service,
Network Time Protocol, and Network
Information Service providers, and to avoid
potential problems with multi-threaded
process deadlocks when stressing fork(2)
and directory(3C) (see JAGae84101), this
patch is required.
A.02.07.xx11i v1PHCO_36184
Fixes in this Release
Unless listed in the Known Problems and Workarounds section, all previous WBEM Services
A.02.05 known problems have been fixed in WBEM Services A.02.07.
Table 1-8 Defects Fixed in HP WBEM Services A.02.07.04
ResolutionDescriptionIdentifier
Defects fixed in HP WBEM Services A.02.07.04
The warning has been changed to a NOTE.
In addition, when the system is restarted after
installing HP WBEM Services, the
cimserver_rc process tries to ensure that the
SSL certificates are generated appropriately. Run
the gen_wbem_certs tool with the -verify
option to verify if the certificates are generated
properly or not. If the certificates are not
generated properly, then run the
gen_wbem_certs tool again.
After cold-installing DC-OE or VSE-OE,
the following warning message is logged
in the /var/adm/sw/swagent.log file:
Warning: Cannot find the
fully-qualified domain name
(FQDN) for this system, SSL
certificates for WBEM Services
are created with the short host
name.
At installation, the SSL certificates for HP
WBEM Services is created with a short
host name. This occurs because the
Fully-Qualified Domain Name (FQDN)
may not be available.
QXCR1000823357
The error message displayed in this scenario has
been modified to indicate the nature of the error
and the remedial action.
The error message indicates that there could be
a problem with the permissions of the
cimserver trust store path and that the
cimserver cannot be restarted.
Following is the error message that is displayed:
# cimserver PGS10033: The CIM Server
is not started: PGS00415: SSL
exception: PGS13312: Could not
access the trust store. Check the
permissions of the trust store path
"/etc/opt/hp/sslshare/cimserver_trust".
If the permissions of the cimserver trust
store path /etc/opt/hp/sslshare are
corrupt or incorrect, then the cimserver
does not start up.
The following error message is displayed:
PGS10033: The CIM Server is not
started: PGS00415: SSL
exception: PGS13302: The
"sslTrustStoreUserName"
property must specify a
truststore user name to
associate with the trusted
certificates if
sslClientVerificationMode" is
'required' or 'optional', and
a trust store is specified.
The error message does not provide
sufficient detail on the problem and does
not indicate the corrective steps that need
to be taken.
QXCR1000865453
22 HP WBEM Services Version A.02.07 Release Notes