HP WBEM Services for HP-UX System Administrator Guide (766166-001, March 2014)

Table 1 Commands, Executable Scripts, and Daemon Processes in HP WBEM Services (continued)
To Perform
Required
PermissionVersionTypeName
However, you can set the interval for this
daemon.
Normally, the CIM server is started and halted
using the cimserver command. If you halt the
CIM server using the cimserver command,
the daemon does not automatically restart it in
the event of a failure.
For more information on using this command,
see cimserverd(1M).
This process is the main executable for the
WBEM server. This process can only be used
YesA.02.07Processcimservermain
with the cimserver command. The
cimserver executable runs as the root user
to perform privileged operations for the WBEM
Server. The cimservermain runs as cimsrvr
user to perform all WBEM Server functions that
do not require privileged access.
The cimtrust command is used to add,
remove or list X509 certificates in the PEM
YesA.02.07Commandcimtrust
format in the WBEM Server trust store. If the
HTTPS connection and client verification is
enabled on the WBEM Server, clients must use
this command to add their certificates to the
WBEM Server trust store.
The cimsub command provides a command
line interface to manage the CIM indication
subscriptions on the local CIM server.
any userA.02.09.06Commandcimsub
This script is used to generate WBEM
certificates. This script must be used to generate
YesA.02.07.02Scriptgen_wbem_certs
certificates only when the existing certificates
get corrupted. From version A.02.09 onwards,
this script can also be used to verify existing
WBEM certificates.
Initializes the repository.rootA.02.07Scriptinit_repository
If the repository is moved or corrupted, you must
first attempt to restore it from backup. If you
cannot restore the repository from the backup,
use the init_repository script to restore the
repository to the state it was in, when HP WBEM
Services was installed. You will lose all provider
data that was loaded in the repository after the
initial installation. You must re-install any
providers that you had added.
Use this command only when the CIM server is
running.
Runs as a HP WBEM Services client that gathers
information about the operating system where
any userA.02.07Commandosinfo
the command is issued. The command uses the
Operating System Provider, which is bundled
with HP WBEM Services for HP-UX.
The response lists some properties of the class,
including the hostname, operating system type,
version, user license, OS capability (32- or
64-bit), last boot time, local date time, and
system uptime.
16 Introduction to HP WBEM Services