HP-UX WBEM Fibre-Channel Instance Provider Datasheet, April 2010

uint16 Op
erationalStatus
Inherited from
CIM_ManagedSystemElement
HP
-
UX:
A
n integer value that has the following
mappings.
0="Unknown", 2="OK",
6="Error",10="Stopped",11="In service",
15="Dormant",
string OSDeviceName
Local to HPUX_FCPort
HP
-
UX:
A
string that spec
i
fies the HP
-
UX specific name,
(for example, /dev/td0).
string OtherLinkTechnology
Inherited from CIM_NetworkPort
HP
-
UX:
A
string describing LinkTechnology when
LinkTechnology (above) is set to 1("Other").
string OtherNetworkPortType
Inherited from CI
M_NetworkPort
HP
-
UX:
A
string that d
escribes the type of module
when
the port type is set to 1 ("Other").
string PermanentAddress
Inherited from CIM_NetworkPort
HP
-
UX:
A
string that specifies the port WWN
.
uint16 PortNumber
Inherited from CIM_NetworkPort
HP
-
UX:
A
n integer value specifying the port number.
Network ports are often numbered relative to either a
logical modules or a network element.
string PortSymbolicName
Local to HPUX_FCPort
HP
-
UX:
A
string that denotes the port name.
uint16 PortType
Inh
erited from CIM_
Network
Port
HP
-
UX:
A
n integer that
specifies the
topology of port
.
Values are "Unknown=0", "Other"=1, "N"=10,
"NL"=11, "F/NL"=12, "Nx"=13, "E"=14,
"F"=15, "FL"=16, "B"=17, "G"=18.
uint64 Speed
Inherited from CIM_
Logical
Port
HP
-
UX:
A
n integ
er that specifies the current speed of the
port.
Speed of zero represents a link not established.
1Gb is 1062500000 bps
2 Gb is 2125000000 bps
4 Gb is 4250000000 bps
10 Gbs single channel variant is 10518750000 bps
10 Gb four channel variant is 12750000000 bps
This is the raw bit rate.
uint16 SupportedCOS
Inherited from CIM_FCPort
HP
-
UX:
A
n integer indicating the
supported
Fibre
Channel Classes of Service.
uint64
SupportedMaximumTransmissionUnit
Inherited from CIM_NetworkPort
HP
-
UX:
A
n integer that speci
fies the maximum frame size
supported by the port.
Table 3: HPUX_FCLogicalPortGroup properties
Table 3 describes the properties of the HPUX_FCLogicalPortGroup class. It has three columns. The first is the property name (including type and
units), the second lists the property inheritance (indicating which class or super class defines the property), and the third discusses the property
description and its value. Each row describes a property. Note: while some properties in the table are marked with the “Write” qualifier (based
on their designation in the DMTF CIM schema), all properties are in fact read-only for this version of the HP-UX FC Provider.
Property Name Property Inheritance Property Description (and value)