HP-UX ProviderSvcsBase Administrator Guide, September 2012
Table Of Contents
- HP-UX ProviderSvcsBase administrator guide
- Contents
- 1 Introduction
- 2 Installing the PSB Software
- 3 Using PSB Components
- 4 Troubleshooting PSB
- A PSB configuration files
- Support and Other Resources
- 5 Documentation feedback
Figure 1 SD Install Software Selection Window
4. In the Specify Source window, select the appropriate location where the depot is available
and click OK. The SD Install - Software Selection window is displayed.
5. In the SD Install - Software Selection window, select Options-> Autoselect dependencies when
marking software.
6. Select Enforce dependency analysis errors in agent, and click OK, as shown in the following
figure. The Note window is displayed.
Selecting these options automatically installs all the dependencies.
NOTE: The system selects some options by default. However, you must select the two options
mentioned in step 5 and step 6 to automatically install the prerequisites.
7. Click OK in the Note window to confirm the selection of dependencies.
8. In the SD Install - Software Selection window, select Actions->Install to begin installation, as
shown in the following figure:
NOTE: The PSB software is automatically configured after it is installed.
6 Installing the PSB Software