HP-UX ProviderSvcsBase Administrator Guide, September 2012
Table Of Contents
- HP-UX ProviderSvcsBase administrator guide
- Contents
- 1 Introduction
- 2 Installing the PSB Software
- 3 Using PSB Components
- 4 Troubleshooting PSB
- A PSB configuration files
- Support and Other Resources
- 5 Documentation feedback
3. For information about installation-related errors, enter the following command at the HP-UX
prompt:
# swjob -a log <jobid> @ <system name>:/
For example, enter the following command at the HP-UX prompt:
# swjob -a log hpdst6-0004 @ hpdst.cup.hp.com:/
Removing the PSB Software
This section describes how to remove the PSB software using the TUI and the CLI.
CAUTION: Removing the PSB software makes your system vulnerable to failure. Also, all the
software products that depend on the PSB software may not work properly.
Removing the Software Using the TUI
To remove the PSB software from your system, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swremove
3. Select ProviderSvcsBase in the SD Remove window, as shown in the following figure:
Removing the PSB Software 11