HP-UX ProviderSvcsBase Administrator Guide, September 2012
Table Of Contents
- HP-UX ProviderSvcsBase administrator guide
- Contents
- 1 Introduction
- 2 Installing the PSB Software
- 3 Using PSB Components
- 4 Troubleshooting PSB
- A PSB configuration files
- Support and Other Resources
- 5 Documentation feedback
The Logfile, which includes details about the installation, is displayed. If there are no errors
in the Logfile, the PSB software is installed properly. If the PSB software is not installed
appropriately, then error messages are logged in this file. You need to rectify these errors and
re-install PSB. To re-install PSB repeat this procedure.
3. For information about errors related to installation, enter the following command at the HP-UX
prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile, as underlined in the Logfile window, in the following
figure:
For example, enter the following command at the HP-UX prompt:
# swjob -a log hpdst6-0004 @ hpdst6.cup.hp.com:/
Verifying the Installation Using the CLI
This section provide CLI steps to verify the software installation.
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the PSB software is installed properly. Otherwise, you must
install the PSB software again.
A sample output is shown in the following figure:
10 Installing the PSB Software