HP-UX ProviderSvcsBase Administrator Guide, September 2011

9. Unmount the CD.
# unmount /tmp/cdrom
10. Verify the installation.
# swlist | grep ProviderSvcsBase
If the PSB software is installed, product and the version number of the PSB™ software are
displayed in the output. If the PSB™ software is not installed properly, you must repeat the
installation procedure. For more information, see “Verifying the Installation” (page 9).
Installing Using the CLI
To install the PSB™ software using CLI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice.
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Install the PSB™ software and all the dependencies.
# swinstall -x autoselect_dependencies=true -x
enforce_dependencies=true -s /tmp/cdrom ProviderSvcsBase
4. Unmount the CD.
# unmount /tmp/cdrom
5. Verify whether the PSB™ software is installed.
# swlist | grep ProviderSvcsBase
If the PSB™ software is installed, PSB™ and the version number of the PSB™ software appear
in the output. If the PSB™ software is not installed properly, you must repeat the installation
procedure. For more information, see “Verifying the Installation” (page 9).
Installing the PSB Software from the Web
To install the PSB™ software from the Software Depot, complete the following steps:
1. Go to HP Software Depot at: http://www.hp.com/go/softwaredepot
2. Search for ProviderSvcsBase™. The Overview page is displayed.
8 Installing the PSB Software