HP-UX ProviderSvcsBase Administrator Guide, September 2011

2 Installing the PSB Software
The PSB™ software is installed by default with the HP-UX 11i v3 Operating Environment (OE)
media. However, at some point you may need to install the PSB™ software separately. This chapter
describes how to install the PSB™ software as a standalone component on the HP-UX 11i v3
operating system.
Following are the topics discussed in this chapter:
• “Prerequisites” (page 5)
• “Installing the PSB Software from the Media” (page 5)
• “Installing the PSB Software from the Web” (page 8)
• “Verifying the Installation” (page 9)
• “Removing the PSB Software” (page 11)
• “Verifying Removal of the PSB Software” (page 13)
Prerequisites
This section provides information about the prerequisites for installing September 2011 version
(C.06.00.04.02) of PSB™ software
• Event Manager (EVM) HP-UX 11i v3 March 2009 release or later
• SysFaultMgmt March 2009 release or later
• WBEM Services Version A.02.09
• SysMgmtPlus Version A.03.00, March 2010 release or later
Installing the PSB Software from the Media
This section describes the two ways in which you can install the PSB™ software from the HP-UX
11i v3 OE media:
• Using the terminal user interface (TUI)
• Using the command-line interface (CLI)
Installing Using the TUI
To install the PSB™ software using the TUI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice. For example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Enter the following command at the HP-UX prompt:
# swinstall
The SD Install - Software Selection window appears:
Prerequisites 5