HP-UX ProviderSvcsBase Administrator Guide, September 2011

2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the PSB™ software is removed successfully. If the PSB™ software
is not removed properly, you must repeat the removal procedure. See “Removing the PSB
Software” (page 11) for instructions on how to remove the PSB™ software.
3. For information about errors related to the removal of the PSB™ software, enter the following
command at the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the output of the swjob command.
14 Installing the PSB Software