HP-UX ProviderSvcsBase Administrator Guide, September 2011

3. For information about installation-related errors, enter the following command at the HP-UX
prompt:
# swjob -a log <jobid> @ <system name>:/
For example, enter the following command at the HP-UX prompt:
# swjob -a log hpdst6-0004 @ hpdst.cup.hp.com:/
Removing the PSB Software
This section describes how to remove the PSB™ software using the TUI and the CLI.
CAUTION: Removing the PSB™ software makes your system vulnerable to failure. Also, all the
software products that depend on the PSB™ software may not work properly.
Removing the Software Using the TUI
To remove the PSB™ software from your system, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swremove
3. Select ProviderSvcsBase™ in the SD Remove window, as shown in the following figure:
Removing the PSB Software 11