HP-UX ProviderSvcsBase Administrator Guide, September 2011

The Logfile, which includes details about the installation, is displayed. If there are no errors
in the Logfile, the PSB™ software is installed properly. If the PSB software is not installed
appropriately, then error messages are logged in this file. You need to rectify these errors and
re-install PSB. To re-install PSB repeat this procedure.
3. For information about errors related to installation, enter the following command at the HP-UX
prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile, as underlined in the Logfile window, in the following
figure:
For example, enter the following command at the HP-UX prompt:
# swjob -a log hpdst6-0004 @ hpdst6.cup.hp.com:/
Verifying the Installation Using the CLI
This section provide CLI steps to verify the software installation.
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
If the output contains no errors, the PSB™ software is installed properly. Otherwise, you must
install the PSB™ software again.
A sample output is shown in the following figure:
10 Installing the PSB Software