Administrator's Guide

2 Installing the PSB Software
This chapter describes how to install the PSB software on the HP-UX 11i v3 operating system.
Following are the topics discussed in this chapter:
• “Prerequisites” (page 5)
• “Installing the PSB Software from the Media” (page 5)
• “Installing the PSB software from the web” (page 8)
• “Verifying the Installation” (page 9)
• “Removing the PSB Software” (page 11)
• “Verifying Removal of the PSB Software” (page 13)
Prerequisites
This section provides information about the prerequisites for installing March 2013 version
C.12.00.07.01 of PSB software
Table 1 ProviderSvcsBase software requirements
Product versionProduct
B.11.31Event Manager (EVM)
C.07.06.03 March 2012 web release or laterSysFaultMgmt
A.05.00.09.01, March 2011 release or laterSysMgmtPlus
A.02.09.02.00 or laterWBEM Services
Installing the PSB Software from the Media
This section describes the two ways in which you can install the PSB software from the HP-UX 11i
v3 OE media:
• Using the terminal user interface (TUI)
• Using the command-line interface (CLI)
Installing Using the TUI
To install the PSB software using the TUI, complete the following steps:
1. Log in to the system as a superuser.
2. Mount the CD to a location of your choice. For example:
# mount /dev/dsk/c1t2d0 /tmp/cdrom
3. Enter the following command at the HP-UX prompt:
# swinstall
The SD Install - Software Selection window appears:
Prerequisites 5