Administrator's Guide

A PSB configuration files
This appendix describes the items of configuration files in PSB.
oserrlogd.cfg
Users can tune the oserrlogd daemon configuration parameters, if required. The following
configuration parameters are available in /var/opt/psb/conf/oserrlogd.cfg file.
Table 2 oserrlogd file configuration parameters
DescriptionUser configurableValue rangeDefault valueParameter
Specifies the maximum number
of circular files used for
logging.
Yes1 to 21474836478PSB_NUM_LOG_FILES
Specifies the maximum size of
a single log file (=specified
Yesgreater than 200200PSB_LOG_FILE_SIZE
value *1024 bytes, which is
an indicative maximum log file
size).
Indicates the log rate threshold
as the number of errors per
minute.
YesNA20PSB_LOG_RATE_THRESHOLD
Indicates the amount of free
disk space available for use,
YesNA95PSB_DISK_THRESHOLD
as a percentage of the total
capacity, on the/var
filesystem to log system errors.
Specifies the read interval time
in secs at which the
YesNA10PSB_DIAG2_READ_INTERVAL
osserlogd daemon reads
from the diag2 driver.
WARNING! Changes to the configuration file can affect all clients that consume events from
oserrlogd daemon, hence these values must be changed only after due consideration. HP
recommends not to change the values for the PSB_LOG_FILE_PATH and PSB_LOG_FILE_NAME
parameters.
oserrlogd.cfg 19