Manualshelf

Administrator's Guide

ManualsBrandsHP ManualsSoftwareHP-UX 11i WBEM Software
11121314151617181920
6. Click OK in the Remove Analysis window to confirm the removal of the PSB software.
7. When the PSB software is removed, the Remove Window is displayed.
8. Verify whether the PSB software is removed properly.
# swlist | grep ProviderSvcsBase
If the PSB software is removed properly, PSB and the version number of the PSB software does
not appear in the output. If the PSB software is not removed properly, you must repeat the
removal procedure. For more information, see “Verifying Removal of the PSB Software”
(page 13).
NOTE: Before removing the PSB software, ensure that WBEM Providers are not accessing the
software.
Removing the Software Using the CLI
To remove the PSB software from your system, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX command prompt.
# swremove ProviderSvcsBase
3. Verify if the PSB software is removed.
# swlist | grep ProviderSvcsBase
If the PSB software is removed properly, PSB and the version number of the PSB software do
not appear in the output. If the PSB software is not removed properly, you must repeat the
removal procedure. For more information, see “Verifying Removal of the PSB Software”
(page 13).
Verifying Removal of the PSB Software
This section describes how to use the TUI and the CLI to verify whether the PSB software is removed
successfully.
Verifying Removal Using the TUI
To verify whether the PSB software is removed successfully, complete the following steps:
1. Log in to the system as a superuser.
2. Click Logfile in the Remove Window.
If there are no errors in the Logfile, the PSB software is removed successfully. If the PSB
software is not removed properly, you must repeat the removal procedure. See “Removing
the PSB Software” (page 11) for instructions on how to remove the PSB software.
3. For information about errors related to the removal of PSB, enter the following command at
the HP-UX prompt:
# swjob -a log <jobid> @ <system name>:/
The jobid is available in the Logfile.
Verifying Removal Using the CLI
To verify if the PSB software is removed successfully, complete the following steps:
1. Log in to the system as a superuser.
2. Enter the following command at the HP-UX prompt:
# swjob
Verifying Removal of the PSB Software 13