Veritas Volume Manager 5.0.1 Troubleshooting Guide, HP-UX 11i v3, First Edition, November 2009

One of the disk groups specified in a disk group move, split or join operation is
currently involved in another unrelated disk group move, split or join operation
(possibly as the result of recovery from a system failure).
Recommended action:
Use the vxprint command to display the status of the disk groups involved. If
vxprint shows that the TUTIL0 field for a disk group is set to MOVE, and you are
certain that no disk group move, split or join should be in progress, use the vxdg
command to clear the field.
See “Recovering from an incomplete disk group move” on page 27.
Otherwise, retry the operation.
V-5-1-2862
VxVM vxdg ERROR V-5-1-2862 object: Operation is not supported
Description:
DCO and snap objects dissociated by Persistent FastResync, and VVR objects
cannot be moved between disk groups.
Recommended action:
No action is necessary. The operation is not supported.
V-5-1-2866
VxVM vxdg ERROR V-5-1-2866 object: Record already exists in disk
group
Description:
A disk group join operation failed because the name of an object in one disk group
is the same as the name of an object in the other disk group. Such name clashes
are most likely to occur for snap objects and snapshot plexes.
Recommended action:
Use the following command to change the object name in either one of the disk
groups:
# vxedit -g diskgroup rename old_name new_name
See the vxedit(1M) manual page.
101Error messages
Types of messages