Veritas Volume Manager 5.0.1 Troubleshooting Guide, HP-UX 11i v3, First Edition, November 2009

file should contain a supported protocol version before trying to bring the node
into the cluster.
Recommended action:
Verify the supported cluster protocol versions using the vxdctl protocolversion
command. The volboot file should contain a supported protocol version before
trying to bring the node into the cluster. Run vxdctl init to write a valid protocol
version to the volboot file. Restart vxconfigd and retry the join.
V-5-1-4220
VxVM vxconfigd ERROR V-5-1-4220 DG move: can’t import diskgroup,
giving up
Description:
The specified disk group cannot be imported during a disk group move operation.
(The disk group ID is obtained from the disk group that could be imported.)
Recommended action:
The disk group may have been moved to another host. One option is to locate it
and use the vxdg recover command on both the source and target disk groups.
Specify the -o clean option with one disk group, and the -o remove option with
the other disk group.
See “Recovering from an incomplete disk group move” on page 27.
V-5-1-4267
VxVM vxassist WARNING V-5-1-4267 volume volume already has at least
one snapshot plex Snapshot volume created with these plexes will have
a dco volume with no associated dco plex.
Description:
An error was detected while adding a DCO object and DCO volume to a mirrored
volume. There is at least one snapshot plex already created on the volume. Because
this snapshot plex was created when no DCO was associated with the volume,
there is no DCO plex allocated for it.
Recommended action:
For information on adding DCO volumes and volume snapshots, see the Veritas
Volume Manager Administrator’s Guide.
111Error messages
Types of messages