Veritas Volume Manager 5.0 Troubleshooting Guide, HP-UX 11i v3, First Edition, May 2008

77Error messages
Understanding messages
■ Action: Reinitialize the disks in the group with larger log areas. Note that
this requires that you restore data on the disks from backups. See the
vxdisk(1M) manual page. To reinitialize all of the disks, detach them from
the group with which they are associated, reinitialize and re-add them. Then
deport and re-import the disk group to effect the changes to the log areas for
the group.
V-5-1-579
VxVM vxconfigd ERROR V-5-1-579 Disk group group: Errors in some
configuration copies: Disk disk, copy number: [Block number]: reason
...
■ Description: During a failed disk group import, some of the configuration
copies in the named disk group were found to have format or other types of
errors which make those copies unusable. This message lists all
configuration copies that have uncorrected errors, including any
appropriate logical block number. If no other reasons are displayed, then
this may be the cause of the disk group import failure.
■ Action: If some of the copies failed due to transient errors (such as cable
failures), then a reboot or re-import may succeed in importing the disk
group. Otherwise, the disk group configuration may have to be restored. You
can recreate a disk group configuration by using the procedures given in
“Restoring a disk group configuration” on page 49
V-5-1-583
VxVM vxconfigd ERROR V-5-1-583 Disk group group: Reimport of disk
group failed: reason
■ Description: After vxconfigd was stopped and restarted (or disabled and
then enabled), VxVM failed to recreate the import of the indicated disk
group. The reason for failure is specified. Additional error messages may be
displayed that give further information describing the problem.
■ Action: A major cause for this kind of failure is disk failures that were not
addressed before vxconfigd was stopped or disabled. If the problem is a
transient disk failure, then rebooting may take care of the condition. The
error may be accompanied by messages such as ‘‘Disk group has no valid
configuration copies.’’ This indicates that the disk group configuration
copies have become corrupt (due to disk failures, writing on the disk by an
application or the administrator, or bugs in VxVM). You can recreate a disk
group configuration by using the procedures given in “Restoring a disk
group configuration” on page 49.