Veritas Volume Manager 5.0 Troubleshooting Guide Guide (September 2006)

91Error messages
Understanding messages
V-5-1-3689
VxVM vxassist ERROR V-5-1-3689 Volume record id rid is not found in
the configuration.
■ Description: An error was detected while reattaching a snapshot volume using
snapback. This happens if a volume’s record identifier (rid) changes as a result of a
disk group split that moved the original volume to a new disk group. The snapshot
volume is unable to recognize the original volume because its record identifier has
changed.
■ Action: Use the following command to perform the snapback:
# vxplex [-g diskgroup] -f snapback volume plex
V-5-1-3828
VxVM vxconfigd ERROR V-5-1-3828 upgrade operation failed: Already at
highest version
■ Description: An upgrade operation has failed because a cluster is already running at
the highest protocol version supported by the master.
■ Action: No further action is possible as the master is already running at the highest
protocol version it can support.
V-5-1-3848
VxVM vxconfigd ERROR V-5-1-3848 Incorrect protocol version (number)
in volboot file
■ Description: A node attempted to join a cluster where VxVM software was
incorrectly upgraded or the volboot file is corrupted, possibly by being edited
manually. The volboot file should contain a supported protocol version before
trying to bring the node into the cluster.
■ Action: Verify the supported cluster protocol versions using the vxdctl
protocolversion command. The volboot file should contain a supported
protocol version before trying to bring the node into the cluster. Run vxdctl init
to write a valid protocol version to the volboot file. Restart vxconfigd and retry
the join.
V-5-1-4220
VxVM vxconfigd ERROR V-5-1-4220 DG move: can’t import diskgroup,
giving up
■ Description: The specified disk group cannot be imported during a disk group move
operation. (The disk group ID is obtained from the disk group that could be
imported.)