VERITAS Volume Manager 4.1 Troubleshooting Guide

Error Messages
Understanding Messages
Chapter 6 105
• Description: An error was detected while adding a DCO object and DCO volume to a
mirrored volume. There is at least one snapshot plex already created on the volume.
Because this snapshot plex was created when no DCO was associated with the volume,
there is no DCO plex allocated for it.
• Action: See the section Adding a Version 0 DCO and DCO Volume in the chapter
Administering Volume Snapshots of the VERITAS Volume Manager Administrator’s
Guide.
V-5-1-4277
VxVM vxconfigd ERROR V-5-1-4277 cluster_establish: CVM protocol
version out of range
• Description: When a node joins a cluster, it tries to join at the protocol version that is
stored in its volboot file. If the cluster is running at a different protocol version, the
master rejects the join and sends the current protocol version to the slave. The slave
re-tries with the current version (if that version is supported on the joining node), or the
join fails.
• Action: Make sure that the joining node has a VERITAS Volume Manager release
installed that supports the current protocol version of the cluster.
V-5-1-4551
VxVM vxconfigd ERROR V-5-1-4551 dg_move_recover: can’t locate disk(s),
giving up
• Description: Disks involved in a disk group move operation cannot be found, and one of
the specified disk groups cannot be imported.
• Action: Manual use of the vxdg recover command may be required to clean the disk group
to be imported. See “Recovering from Incomplete Disk Group Moves” on page 28" for more
information.
V-5-1-4620
VxVM vxassist WARNING V-5-1-4620 Error while retrieving information
from SAL
• Description: The vxassist command does not recognize the version of the SAN Access
Layer (SAL) that is being used, or detects an error in the output from SAL.