VERITAS Volume Manager 4.1 Troubleshooting Guide

Error Messages

Understanding Messages

Chapter 6 103

V-5-1-3243

VxVM vxdmpadm ERROR V-5-1-3243 The VxVM restore daemon is already

running. You can stop and restart the restore daemon with desired

arguments for changing any of its parameters.

• Description: The vxdmpadmstartrestore command has been executed while the restore

daemon is already running.

• Action: Stop the restore daemon and restart it with the required set of parameters as

shown in the vxdmpadm(1M) manual page.

V-5-1-3362

VxVM vxdmpadm ERROR V-5-1-3362 Attempt to disable controller failed.

One (or more) devices can be accessed only through this controller.

Use the -f option if you still want to disable this controller.

• Description: Disabling the controller could lead to some devices becoming inaccessible.

• Action: To disable the only path connected to a disk, use the -f option.

V-5-1-3486

VxVM vxconfigd ERROR V-5-1-3486 Not in cluster

• Description: Checking for the current protocol version (using vxdctlprotocol version)

does not work if the node is not in a cluster.

• Action: Bring the node into the cluster and retry.

V-5-1-3689

VxVM vxassist ERROR V-5-1-3689 Volume record id rid is not found in the

configuration.

• Description: An error was detected while reattaching a snapshot volume using snapback.

This happens if a volume’s record identiﬁer (rid) changes as a result of a disk group split

that moved the original volume to a new disk group. The snapshot volume is unable to

recognize the original volume because its record identiﬁer has changed.

• Action: Use the following command to perform the snapback:

# vxplex [-g diskgroup] -f snapback volume plex