Veritas Volume Manager 4.1 Troubleshooting Guide (HP-UX 11i v3, February 2007)

Chapter 6, Error Messages

Understanding Messages

V-5-1-809

VxVM vxplex ERROR V-5-1-809 Plex plex in volume volume is locked by

another utility.

◆ Description: The vxplex command fails because a previous operation to attach a plex

did not complete. The vxprint command should show that one or both of the

temporary and persistent utility fields (TUTIL0 and PUTIL0) of the volume and one

of its plexes are set.

◆ Action: If the vxtask list command does not show a task running for the volume,

use the vxmend command to clear the TUTIL0 and PUTIL0 fields for the volume and

all its components for which these fields are set:

# vxmend -g diskgroup clear all volume plex ...

V-5-1-923

VxVM vxplex ERROR V-5-1-923 Record volume is in disk group diskgroup1

plex is in group diskgroup2.

◆ Description: An attempt was made to snap back a plex from a different disk group.

◆ Action: Move the snapshot volume into the same disk group as the original volume.

V-5-1-1171

VxVM vxconfigd ERROR V-5-1-1171 Version number of kernel does not

match vxconfigd

◆ Description: The release of vxconfigd does not match the release of the VERITAS

Volume Manager kernel drivers. This should happen only as a result of upgrading

VxVM, and then running vxconfigd without a reboot.

◆ Action: Reboot the system. If that does not cure the problem, re-add the VxVM

packages.

V-5-1-1186

VxVM vxconfigd ERROR V-5-1-1186 Volume volume for mount point /usr not

found in bootdg disk group

◆ Description: The system is configured to boot with /usr mounted on a volume, but

the volume associated with /usr is not listed in the configuration of the boot disk

group. There are two possible causes of this error: