Veritas Volume Manager 4.1 Troubleshooting Guide (HP-UX 11i v3, February 2007)

Understanding Messages
92 VERITAS Volume Manager Troubleshooting Guide
V-5-1-4267
VxVM vxassist WARNING V-5-1-4267 volume volume already has at least
one snapshot plex
Snapshot volume created with these plexes will have a dco volume with
no associated dco plex.
◆ Description: An error was detected while adding a DCO object and DCO volume to a
mirrored volume. There is at least one snapshot plex already created on the volume.
Because this snapshot plex was created when no DCO was associated with the
volume, there is no DCO plex allocated for it.
◆ Action: See the section “Adding a Version 0 DCO and DCO Volume” in the chapter
“Administering Volume Snapshots” of the VERITAS Volume Manager Administrator’s
Guide.
V-5-1-4277
VxVM vxconfigd ERROR V-5-1-4277 cluster_establish: CVM protocol
version out of range
◆ Description: When a node joins a cluster, it tries to join at the protocol version that is
stored in its volboot file. If the cluster is running at a different protocol version, the
master rejects the join and sends the current protocol version to the slave. The slave
re-tries with the current version (if that version is supported on the joining node), or
the join fails.
◆ Action: Make sure that the joining node has a VERITAS Volume Manager release
installed that supports the current protocol version of the cluster.
V-5-1-4551
VxVM vxconfigd ERROR V-5-1-4551 dg_move_recover: can’t locate disk(s),
giving up
◆ Description: Disks involved in a disk group move operation cannot be found, and one
of the specified disk groups cannot be imported.
◆ Action: Manual use of the vxdg recover command may be required to clean the
disk group to be imported. See “Recovering from Incomplete Disk Group Moves” on
page 18 for more information.