VERITAS Volume Manager 4.1 Administrator's Guide

Administering Dynamic Multipathing (DMP)
Displaying Multipaths to a VM Disk
Chapter 3 131
iosize: min=1024 (bytes) max=64 (blocks)
public: slice=0 offset=1152 len=4101723
private: slice=0 offset=128 len=1024
update: time=962923719 seqno=0.7
headers: 0 248configs: count=1 len=727
logs: count=1 len=110
Defined regions:
config priv 000017-000247[000231]:copy=01 offset=000000 disabled
config priv 000249-000744[000496]:copy=01 offset=000231 disabled
log priv 000745-000854[000110]:copy=01 offset=000000 disabled
lockrgn priv 000855-000919[000065]: part=00 offset=000000
Multipathing information:
numpaths: 2
c1t0d3 state=enabled type=secondary
c4t1d3 state=disabled type=primary
In the Multipathing information section of this output, the numpaths line shows that there
are 2 paths to the device, and the following two lines show that the path to c1t0d3 is active
(state=enabled) and that the other path c4t1d3 has failed (state=disabled).
The type field is shown for disks on active/passive type disk arrays. This field indicates the
primary and secondary paths to the disk.
The type field is not displayed for disks on active/active type disk arrays. Such arrays have no
concept of primary and secondary paths.