Veritas Volume Manager 4.1 Administrator's Guide (HP-UX 11i v3, February 2007)

Chapter 14, Using VERITAS Storage Expert
Running Storage Expert
383
The following options may be specified:
-d defaults_file Specify an alternate defaults file.
-g diskgroup Specify the disk group to be examined.
-v Specify verbose output format.
One of the following keywords must be specified:
check List the default values used by the rule’s attributes.
info Describe what the rule does.
list List the attributes of the rule that you can set.
run Run the rule.
A full list of the Storage Expert rules and their default values are listed in “Rule
Definitions and Attributes” on page 393.
Discovering What a Rule Does
To obtain details about what a rule does, use the info keyword, as in the following
example:
# vxse_stripes2 info
VxVM vxse:vxse_stripes2 INFO V-5-1-6153 This rule checks for stripe
volumes which have too many or too few columns
Displaying Rule Attributes and Their Default Values
To see the attributes that are available for a given rule, use the list keyword. In the
following example, the single attribute, mirror_threshold, is shown for the rule
vxse_drl1:
# vxse_drl1 list
VxVM vxse:vxse_drl1 INFO V-5-1-6004
vxse_drl1 - TUNEABLES default values
----------------------------------------------------------
mirror_threshold - large mirror threshold size
Warn if a mirror is of greater
than this size and does not have
an attached DRL log.