VERITAS Volume Manager 3.2 for HP-UX Release Notes

VERITAS Volume Manager 3.2 for HP-UX Release Notes
Initializing the VERITAS Volume Manager for HP-UX
Chapter 1 61
disks in the disk array, as follows:
Use default disk names for these disks? [y,n,q,?]
(default:y) y
The c1t0d0 disk will be given disk name disk01
The c1t1d0 disk will be given disk name disk02
Hit RETURN to continue.
If you enter n, however, you will be prompted for a disk name for each disk
on the controller, as follows:
Enter disk name for c1t0d0 [<name>,q,?] (default:
disk01)
For each disk, enter the desired disk name and press
<Return>
When all of the disks in the current disk array have been named, press
<Return> to move on to the next disk array.
b. If you select option 2, vxinstall proceeds as follows:
Each disk is handled separately and you are prompted for information on a
per-disk basis. This allows you to install a disk as a pre-existing disk, install it
as a new disk, or leave it alone.
At the following prompt, indicate how you want this disk to be handled:
Installation options for disk enc0
Menu: VolumeManager/Install/Custom/enc/enc0_0
1 Install as a new disk. (discards data on disk!)
2 Leave this disk alone.
? Display help about menu
?? Display help about the menuing system
q Exit from menus
Select an operation to perform:
Options 1 and 2 allow you to initialize the disk or to omit it from installation.
Repeat this step for all disks on the current disk array.
When all of the disks on the current disk array have been named, press
<Return>
to move on to the next disk array.