VERITAS Volume Manager 3.1 Reference Guide

Chapter 2 89
Error Messages
Cluster Error Messages
If the system does not appear to be degraded, stop and restart
vxconfigd and try again.
Vol recovery in progress
• Description
A node that crashed attempted to rejoin the cluster before its DRL
map was merged into the recovery map.
• Action
Retry the join again later (when the merge operation has completed).
Cannot assign minor #
• Description
The slave attempted to join, but an existing volume on the slave has
the same minor number as a shared volume on the master.
This message should be accompanied by the following console
message:
WARNING vxvm:vxconfigd minor number ### disk group group in
use
• Action
Before retrying the join, use vxdg reminor diskgroup ### (see the
vxdg(1M) manual page) to choose a new minor number range either
for the disk group on the master or for the conflicting disk group on
the slave. If there are open volumes in the disk group, the reminor
operation will not take effect until the disk group is deported and
updated either explicitly or through system restart.
Master sent no data
• Description
During the slave join protocol, a message without data was received.
This message is only likely to be seen in the case of a programming
error.
• Action
Contact Customer Support for more information.
Join in progress
• Description