VERITAS Volume Manager 3.1 Administrator's Guide

Disk Tasks
Placing Disks Under Volume Manager Control
Chapter 4 169
If you do not know the address (device name) of the disk to be added,
enter list at the prompt for a complete listing of available disks.
Step 3. To continue the operation, enter y (or press Return) at the following
prompt:
Here are the disks selected. Output format:
[Device_Name]
c3t0d0 c3t1d0 c3t2d0 c3t3d0
Continue operation? [y,n,q,?] (default: y) y
Step 4. To add these disks to the default disk group, rootdg, enter y (or press
Return) at the following prompt:
You can choose to add this disk to an existing disk
group, a
new disk group, or leave the disk available for use by
future
add or replacement operations. To create a new disk
group,
select a disk group name that does not yet exist. To
leave the
disk available for future use, specify a disk group name
of
“none”.
Which disk group [<group>,none,list,q,?] (default:
rootdg) y
Step 5. To allow the vxdiskadm program to use default disk names for each of
the disks, enter y (or Press Return) at the following prompt:
Use default disk names for these disks? [y,n,q,?]
(default: y) y
Step 6. At the following prompt, enter n to indicate that these disks should not
be used as hot-relocation spares:
Add disks as spare disks for rootdg? [y,n,q,?] (default:
n) n
Step 7. When the vxdiskadm program prompts whether to exclude this disk
from hot-relocation use, enter n (or press Return).
Exclude disk from hot-relocation use? [y,n,q,?}
(default: n) n